Publicité
Les langues disponibles
Les langues disponibles
BATTERY CHARGING
USING THE USB CABLE
1.
Attach the USB Cable to the adapter. Connect the other end of the USB Cable to the
Battery.
2.
Plug the adapter into a power source.
USING THE DOCKING STATION (OPTIONAL)
1.
Attach the USB cord to the adapter.
2.
Plug the adapter into a power source.
3.
Turn the Battery upside down and slide the Battery onto the dock.
4.
Press down and the latch will snap into place.
5.
Upon placing the Battery into the charger, the Battery LEDs will alternate for a few seconds
as the charger performs a self-diagnostic of the Battery status.
6.
After diagnostic is complete, the Battery will begin charging with a single LED flashing.
LEDs will become solid as charging progresses. When Battery is fully charged, all LEDs
will become solid and remain ON for 1 hour.
NOTE: If initial alternating light pattern continues for more than 10 seconds, the Battery may
be too warm or too cold to charge. Unplug Battery and allow it to stabilize to a normal room
temperature and try charging again. If Battery is still not charge after this, unplug Battery and
contact customer service.
BATTERY STATUS
LED INDICATORS
○○○○
○○○�
○○��
○���
⛭���
Full charge: The Battery will be fully charged in approximately 3 hours.
NOTE: LED Legend Indicator:
○ = ON
� = OFF
⛭ = FLASH
NOTE: When the Battery is installed or when the appliance is operated, the Battery charge
status LEDs will display for 5 seconds and then turn off. If the Battery charge is 10% or less,
the indicator light will continue to flash until the unit is no longer in use or Battery is removed.
NOTE: It is best to store the Cordless Personal Blender at room temperature.
BLENDER FUNCTION GUIDE
The Blender features 2 push Buttons: ON/OFF (
BATTERY LEVEL
When Battery has only 10% Battery level, 1 LED
starts to flash at rate of 1 second ON/1 second OFF
(0.5 Hz).
) and Pulse (P), allowing you to customize
75–100%
50–75%
25–50%
< 25%
5
Publicité
