Télécharger Imprimer la page

Bosch PS130 Consignes De Fonctionnement/Sécurité page 11

Publicité

Les langues disponibles

Les langues disponibles

BM 2610015935 02-12:BM 2610015935 02-12.qxp 2/6/12 9:45 AM Page 11
BATTERY CHARGE CONDITION
INDICATOR LIGHTS
Your tool is equipped with charge condition
indicator lights (Fig. 7). The indicator lights
shows the charge condition of the battery for a
few second when the On/Off trigger is pressed
halfway or fully.
LED
Continuous lighting 3 x green
Continuous lighting 2 x green
Continuous lighting 1 x green
Flashing light 1 x green
INSERTING AND RELEASING
BATTERY PACK
Release battery pack from tool by pressing on
both sides of the battery release tabs and pull
downward (Fig. 8).
To insert battery, align battery and slide
battery pack into tool until it locks into position.
Do not force.
If battery release tabs are
WARNING
cracked
damaged, do not insert into tool. Battery can
fall out during operation.
1. The charger was designed to fast charge
the battery only when the battery
temperature is between 32˚F (0˚C) and
113˚F (45˚C). If the battery pack is too hot or
too cold, the charger will not fast charge the
battery. (This may happen if the battery pack
is hot from heavy use). When the battery
temperature returns to between 32˚F (0˚C)
and 113˚F (45˚C), the charger will
automatically begin charging.
2. A substantial drop in operating time per
charge may mean that the battery pack is
nearing the end of its life and should be
replaced.
3. Remember to unplug charger during
storage period.
4. If battery does not charge properly:
Capacity
> 2/3
> 1/3
< 1/3
reserve
FIG. 8
or
otherwise
IMPORTANT CHARGING NOTES
in some other electrical device.
light switch which turns power "off" when
lights are turned off.
Clean with cotton swab and alcohol if
necessary.
take or send tool, battery pack and charger
to your local Bosch Service Center. See
"Tools, Electric" in the Yellow Pages for
names and addresses.
Note: Use of chargers or battery packs not
sold by Bosch will void the warranty.
-11-
FIG. 7
1
2
a. Check for voltage at outlet by plugging
b. Check to see if outlet is connected to a
c. Check battery pack terminals for dirt.
d. If you still do not get proper charging,
1

Publicité

loading

Ce manuel est également adapté pour:

Ps130-2aClpk241-120Ps130nPs130bn