Bosch PS130 Consignes De Fonctionnement/Sécurité page 10

BM 2610015935 02-12:BM 2610015935 02-12.qxp 2/6/12 9:45 AM Page 10
DRILL/HAMMER DRILL/DRIVING
MODE SELECTOR RING
The mode selector ring allows the tool to be
set for various drilling/hammer drilling and
driving applications. Rotate the selector ring
right or left depending on the below
applications (Fig. 4).
Driving action: The driving position allows
operation of adjustable clutch for driving
screws and running nuts and bolts.
Drill only action: For drilling in woods,
metals, plastics or other non concrete
materials. The drill position overrides the
clutch for drilling.
Drill with hammer action: For drilling in
concrete, asphalt, tile or other similar hard
materials. The hammer drill position overrides
the clutch for hammer drilling.
ADJUSTABLE CLUTCH
Your tool features 20 clutch settings. Output
torque will increase as the clutch ring, is
rotated from 1 to 20 (Fig. 5).
Attention: The adjustable clutch will only
operate when mode selector ring is in the
driving position.
FIG. 4
Min.
GEAR SHIFTING
Your tool is equipped with two separate gear
ranges, low gear and high gear. Low gear
provides high-torque and slower drilling
speeds for heavy duty work or for driving
screws. High gear provides faster speeds for
drilling lighter work. To change speeds slide
switch, to the high or low position (Fig. 6).
ATTENTION: If your tool appears to be
running, but the chuck will not turn, check to
make sure the gear shifting switch is pushed
fully into desired setting.
When the trigger switch is released it
activates the brake to stop the chuck quickly.
This is especially useful in the repetitive
driving and removal of screws.
AUTOLOCK™
Your tool is equipped with an automatic locking
system. This feature will lock the bit holder in
one position when the trigger switch is
released. This will allow you to tighten or loosen
a nut or screw by rotating the tool by hand with
the switch off. This is convenient when higher
turning torque is needed.
BUILT IN WORK LIGHT
Your tool is also equipped with a light that turns
on automatically when the switch is activated,
for better visibility when drilling/driving (Fig. 1).
-10-
FIG. 5
Max.
FIG. 6
BRAKE