Publicité
Les langues disponibles
Les langues disponibles
BTL6-P510-M _ _ _ _ -E2/E28-KA _ _ /LA _ _
Magnetostrictive Linear Position Sensor – Rod Style
4
Installation and connection
4.1
Installation guidelines
Fig. 4-1:
Installation in hydraulic cylinders
Non-magnetizable material
Headless
setscrew
DIN 914 M5×8
Non-magnetizable material
Fig. 4-2:
Installation in non-magnetizable material
Magnetizable material
If using magnetizable material, the BTL must be protected
against magnetic interference through suitable measures
(e.g. spacer ring made of non-magnetizable material, a
suitable distance from strong external magnetic fields).
Magnet
Fig. 4-3:
Installation in magnetizable material
Rod diameter
E2
10.2 mm
E28
8 mm
Tab. 4-1:
Bore diameter if installed in a hydraulic cylinder
8
english
Magnet
Spacer ring made of
non-magnetizable
material
Bore diameter B
At least 13 mm
At least 11 mm
4.2
Preparing for installation
Installation note: We recommend using non-
magnetizable material to mount the BTL and magnet.
Horizontal assembly: For horizontal assembly with
nominal lengths > 500 mm, support the rod and tighten it
at the end if necessary (only possible with a diameter of
10.2 mm).
Hydraulic cylinder: If installed in a hydraulic cylinder,
ensure that the minimum value for the bore diameter of the
support piston is complied with (see Tab. 4-1).
Fitting bore: The BTL can be fastened in a fitting bore
(Ø 48 H8), but must be sealed with the provided O-ring
and support ring.
The body of the BTL is fastened using 3 M5 threaded pins
at a 120° angle.
Magnet: Various magnets are available for the BTL (see
Accessories on page 12).
Note on EMC characteristics
(only BTL6-P510-...-LA_ _)
EMC characteristics can only be ensured if the
BTL6-P510-...-LA_ _ is completely installed in a
grounded metal housing.
Publicité
