Publicité
Les langues disponibles
Les langues disponibles
Inserting the batteries
Insert the batteries in the open
battery compartment. Only
use batteries of the type AAA
NiMH 1.2 V. Pay attention the
correct polarity. Close the bat-
tery compartment cover.
Charging the batteries
48
Before the handset is used for the first time, insert it in the base
station / charging station for at least 14 hours.
When the handset is properly inserted in the base station / charging sta-
tion, you will hear an acoustic signal. The handset warms up during the
charging process. This is normal and does not represent a risk. Do not
charge the handset with charging units from other manufacturers. The cur-
rent battery charge status is indicated in the display:
Full
Half empty
Automatic answering
If this function is activated, an incoming call is taken when the handset is
removed from the base station. The AUTO ANSWER function is activated
and deactivated using the menu. Refer to Page 70 for the sequence of
menu option selections.
Private branch exchanges
The information on Page 69 explains how to install your telephone in a pri-
vate branch exchange.
All manuals and user guides at all-guides.com
Low radiation operation (ECO mode)
Low
Empty
Putting the Telephone into Operation
Default settings = ECO-mode → OFF
The telephone can be set up so that the radiation frequency is reduced;
. Page 71.
= ECO MODE → ON.
Both in Call mode as well as in Standby mode, the radiation is reduced
considerably when ECO mode is activated as compared to standard, cord-
less DECT telephones.
If necessary, you can increase the range of the telephone system
by switching ECO mode off . Page 71
(ECO MODE → OFF).
63
Publicité
