Blackstone PRO Serie Manuel Du Propriétaire page 21

Model 1820
TroUBLESHooTInG
Visit BLACKSTonEProDUCTS.CoM/SUPPorT for additional
troubleshooting.
Section 01
BAT TERY POWERED IGNITION
SYMPTOMS
01. Burner will not Light with ignition system
02. Pressing the ignitor button does not result in a clicking sound
If ignition does not occur in 5 seconds, turn the burner controls off, wait 5
minutes and repeat the lighting procedure.
If this does not work, to determine the cause, please try to ignite your griddle
with a match. (Please reference the Match Lighting Instructions in the
Cleaning the Burner Assembly section of the Care & Maintenance chapter.)
If you CAN ignite your griddle with a match
POSSIBLE CAUSES
01. Dead battery or no battery.
02. Battery installed incorrectly.
03. Ignitor wire misaligned.
04. Damage to the ignition system.
If you CAN NOT ignite your griddle with a match
POSSIBLE CAUSES
05. Burner tubes are not receiving fuel.
SOLUTION
Replace with new battery.
Ensure that the battery is installed nega-
tive end first.
Ensure that the ignition needle is posi-
tioned 1/8" to 1/4" away from the burner
tube, positioned above a burner hole.
Contact customer service for replace-
ment parts.
SOLUTION
Please reference the Gas Flow section of
the Troubleshooting Chapter.
Troubleshooting | Owner's Manual
Insert one (1) AA battery (not
included) into the battery socket
with the positive terminal facing
out, then screw on the ignitor
button until tight. Be careful to not
over tighten.
3-7mm
Ensure that the ignition needle is
positioned 3-7mm away from the
burner tube, positioned above a
burner hole.
17