Operation - Husqvarna 525PT5S Manuel D'utilisation

5. Tension the chain by turning the chain tensioning
screw clockwise using the combination spanner. The
chain should be tensioned until it does not sag from
the underside of the bar.
6. The chain is correctly tensioned when it does not
sag from the underside of the bar, but can still be
turned easily by hand. Hold up the bar tip and tighten
the bar nuts with the combination spanner.
7. When fitting a new chain, the chain tension has to be
checked frequently until the chain is run-in. Check
the chain tension regularly. A correctly tensioned
chain ensures good cutting performance and long
life.
To adjust the length of the shaft
1. Undo the knob.
Introduction
WARNING:
product, you must read and understand the
safety chapter.
712 - 007 - 28.04.2021

Operation

Before you operate the
2. Pull out the shaft to the desired length.
3. Tighten the knob.
To adjust the harness
Always use the harness when you operate the product.
The harness gives maximum control during operation of
the product. The harness decreases the risk of tiredness
in your arms and back.
1. Put on the harness.
2. Attach the product to the harness support hook.
3. Adjust the length of the harness until the support
hook is roughly level with your right hip.
To check before starting
1. Inspect the working area. Remove any objects that
could be thrown out.
2. Check the saw chain. Never use blunt, cracked or
damaged equipment.
3. Check that the product is in perfect working order.
4. Check that all nuts and screws are tight.
11