Husqvarna ST 430 Manuel D'utilisation page 10

Introduction............................................................. 10
Safety......................................................................11
Assembly................................................................ 14
Operation................................................................ 16
Maintenance........................................................... 18
Product overview
(Fig. 1)
1. Fuel tank cap
2. Oil fill/dipstick
3. Battery cover
4. Discharge chute lever
5. Auger engagement
6. Drive speed lever
7. Control panel
8. Remote control lever
9. Drive engagement
10. Steering triggers
11. Handle knobs
12. Muffler
Product overview
(Fig. 2)
1. Adjustment lever for the auger bucket
2. ON/OFF switch for the heated grip
3. Hour meter and oil change reminder
4. Throttle
5. Discharge chute lever
6. Release lever
7. Ignition slot
8. Auger engagement
9. Drive speed lever
10. Symbols label
11. Remote control lever for the discharge chute
deflector
12. Drive engagement
Product description
The product is a snow thrower that is used to
remove snow from the ground.
Intended use
This product can be used to remove snow from
fields, roads, walkways and driveways. Do not use
it on slopes that are greater than 20°. Do not use the
product in areas where there is much debris, dirt and
protruding stones.
10
Contents
Troubleshooting...................................................... 24
Transportation, storage and disposal......................27
Technical data.........................................................28
Declaration of Conformity....................................... 30
Appendix .............................................................. 147
Introduction
13. Wheel (for ST 424/427/430 only)
14. Continuous track (for ST 424T/427T/430T only)
15. Auger bucket
16. Skid plate
17. Augers
18. Tool for cleaning
19. Discharge chute
20. Discharge chute deflector
21. LED light
22. Oil drain
23. Starter rope handle
24. Hook cover
Symbols on the product
Note:
If the decals on the product are damaged,
contact the distributor to replace them.
(Fig. 3)
(Fig. 4)
(Fig. 5)
(Fig. 6)
(Fig. 7)
(Fig. 8)
(Fig. 9)
(Fig. 10)
(Fig. 11)
(Fig. 12)
(Fig. 13)
Warning.
Read the operator's manual.
Engine on.
Start the engine.
Engine off.
Boost.
Fast.
Slow.
Oil change reminder.
Heated handles.
Remove key before maintenance.
876 - 018 - 11.08.2023