Troubleshooting - Berkel RED LINE 220 Mode D'emploi

8. TROUBLESHOOTING

WARNING: In this chapter the most common problems which occur during use of the slicer are
indicated as well as the necessary operations to eliminate the possible causes. If the problem
persists do not insist in troubleshooting but immediately contact personnel qualified and
authorised by the manufacturer.
PROBLEM
The machine does not start when the
on button is pressed
The machine starts when the on button
is pressed but the operation indicator
light does not turn on
The machine starts but the motor heats
up significantly and emits a foul odour
The machine vibrates
Excessive resistance to cutting of
the product
The blade under stress slows down
or stops
Sharpening is not regular
any more
The sliced product is frayed and of
ineguiar form
When the stop button is pressed the
machine does not stop
Excessive resistance in motion of the
sliding components (product holder,
carriage)
RED LINE
PROBABLE CAUSE
Lack of power
Defective indicator light
Defective motor.
Do not use the machine
Defective transmission
The blade is dull
Loose belt
Springs are excessively dirty.
Worn springs
Dull blade.
Excessively worn blade
Defective control circuit
Sliding guide lubrication
not pertormed periodically
- 220 / 250 / 300
REMEDY
Check that the plug has
been correctly inserted
Do not use the machine
with die indicator light off.
Contact the service centre
Contact the service centre
Contact the service centre
Sharpen the blade
Contact the service centre
Clean the springs.
Replace the springs.
Contact the service centre
Sharpen the blade
Replace the blade.
Contact die service centre
Immediately stop the machine,
removing the plug from the
mains outlet, and immediately
contact the service centre
Carry out periodical lubrication
as described in paragraphs 7.3
and 7.4
19