Medisana HB 675 Mode D'emploi page 18

GB
2 Operating
2.3
Operation
14
Plug the unit into the mains outlet and move the slider control from position
0 to position 1. Operation indicator lamp initially lights up green, then it
flashes red and subsequently it lights up red for the remainder of the warm-
up phase. After a few minutes you will be able to feel the heating blanket
getting noticeably warmer. When the electric blanket reaches the set tempera-
ture, the lamp lights up green again. When the next warm-up phase begins,
operation indicator lamp lights up red again.
If you require a higher temperature setting, move the switch to the next posi-
tions, 2 or 3, or to the maximum heat setting, position 4. Each time switch is
moved, lamp lights up green and then flashes red according to the level at
which the switch is set (two, three or four flashes). The lamp then lights up
again constantly in red for the remainder of the warm-up phase.
Should the heating blanket get too warm for you, slide the switch back to a
lower setting. To switch off the device, return the switch to position 0. The red
power LED will go out, indicating that the unit is switched off. Now unplug the
heating blanket from the mains outlet.
The heating blanket is designed in such a way that settings 1 and 2 are
suitable for continuous use. Push the switch to position 1 or 2 if you want to
use it in continuous operation. The appliance is equipped with an anti-over-
heating device. The heating blanket will switch off automatically after approx.
3 hours of continuous use. To switch it back on, first move the switch back to
position 0 then back to the desired heat setting.
Unplug the heating blanket from the mains outlet when it is no longer in use.