Husqvarna 440e II TrioBrake Manual D'utilisation page 7

Symbols on the machine:
WARNING! Chainsaws can be
dangerous! Careless or improper use
can result in serious or fatal injury to the
operator or others.
Please read the operator's manual
carefully and make sure you understand
the instructions before using the
machine.
Always wear:
• Approved protective helmet
• Approved hearing protection
• Protective goggles or a visor
Both of the operator's hands must be used
to operate the chainsaw.
Never operate a chainsaw holding it with
one hand only.
Contact of the guide bar tip with any object
must be avoided.
Recommended cutting
equipment in this example: -
Bar length 16 inches - Max.
nose radius 10 Teeth - Chain
type Oregon 21LP
Other approved bar and chain
combinations in Operator's Manual.
Measured maximum kickback value with
brake for the bar and chain combination
on the label.
Measured maximum kickback value
without triggering the brake, for the bar
and chain combination on the label.
WARNING! Kickback may occur when
the nose or tip of the guide bar touches
an object, and cause a lightning fast
reverse reaction, kicking the guide bar up
and towards the operator. May cause
serious personal injury.
Ignition; choke: Set the choke control in
the choke position. This should
automatically set the stop switch to the
start position.
1157676-49 Rev.1 2017-05-03
KEY TO SYMBOLS
Air purge
Refuelling.
Chain oil fill.
Chain brake, activated (right) Chain
brake, not activated (left)
The rating plate
showing serial
number. yyyy is
the production
year, ww is the
productionweek.
Other symbols/decals on the machine refer to special
certification requirements for certain markets.
XX
yyyywwxxxxx
English
–
7