Husqvarna 440e II TrioBrake Manual D'utilisation page 33

Low kickback saw chain
A low kickback saw chain is a saw chain that has met the kickback performance requirements of ANSI B175.1-2012
when tested according to the provisions specified in ANSI B175.1-2012.
The saw chain(s) in the list classified as low kickback saw chains are evaluated and listed as a Low Kickback Saw Chain
according to the provisions in Z62.3-11 (R2016).
Kickback and guide bar nose radius
For sprocket nose bars the nose radius is defined by the number of teeth (e.g. 10T). For solid bars the nose radius is
defined by the size of the nose radius. For a given guide bar length, you may use a guide bar with smaller nose radius
than listed.
440e II TrioBrake
Guide bar
Length Pitch
13"
15"
0.325"
16"
18"
13"
15"
0.325"
16"
18"
445e II TrioBrake
Guide bar
Length Pitch
13"
15"
0.325"
16"
18"
13"
15"
0.325"
16"
18"
13"
15"
16" 0.325"
18"
20"
* For guide bars with nominal length 20", two different drive link counts exist. Always check information on the guide bar
to get the correct drive link count for a spare saw chain.
1157676-49 Rev.1 2017-05-03
TECHNICAL DATA
Gauge Max. nose radius
0.050" 10T
0.050" 10T
Gauge Max. nose radius
0.050" 10T
0.050" 10T
10T
0.058"
12T
Saw chain
Type Low kickback
Husqvarna
Yes
SP33G
Husqvarna
Yes
H30
Saw chain
Type Low kickback
Husqvarna
Yes
SP33G
Husqvarna
Yes
H30
Husqvarna
Yes
H25
Drive link count
56
64
66
72
56
64
66
72
Drive link count
56
64
66
72
56
64
66
72
56
64
66
72
78/80*
English – 33