Activating Standby For Remote Operation - Sentiotec Pro B Serie Mode D'emploi

Instructions for use for the user

9.8. Activating standby for remote operation

EN 60335-2-53 specifies that sauna control units with a remote start function
must be set manually to "Standby for remote operation" mode. This activation
must take place again after each remote start and stop procedure. To do so,
perform the following steps:
1. Press the temperature selector
► The remote start indicator 8 starts flashing.
► The sauna control unit is then ready to be started and stopped using
a remote start signal.
► After a remote start and stop, the remote start indicator goes out and the
mode has to be activated again.
for three seconds (longpress).
3
p. 31/38
EN