Draining & Storage; Draining The Brewer - Keurig HOT K-Cup K150 Manuel D'utilisation

P17 20162461 T5274_K150_UCG_FINAL.pdf 4C(CMYK) ZB2319 2016-11-02 Size:8.5X5.5in
Discard water, rinse and refill with water.
25
fig.
Place the Water Reservoir back on the
brewer and replace the Water Reservoir Lid.
(If there is no water in the Water Reservoir,
Place Mug,
simply refill.)
Select
Brew Size
4 Oz.
Be sure the brewer is turned 'ON.' Lift and
2.
lower the Handle on the brewer without
inserting a K-Cup
6 Oz. 8 Oz.
. The LCD Screen will be in its idle state (fig. 4).
3
10 Oz. 12 Oz. 4. Place a large mug on the Drip Tray Plate and
select Large Mug (10 oz. serving) brew size
from the Select Brew Size Menu (fig. 25).
Discard water.
5.
Repeat steps 2 – 5 two more times to
6.
completely purge water from the internal
water tank.

Draining the Brewer

Turn off the brewer, unplug it, and allow the brewer to cool approximately
1.
30 minutes.
Empty the Water Reservoir by first removing the Water Reservoir Lid
2.
from the Water Reservoir then lifting the Water Reservoir straight up
and away from brewer (may be tight). Rinse and empty the
Water Reservoir.
3. Turn the brewer around so the back is facing out. Unscrew the small
knob to release the back panel, remove the panel from the brewer,
pod.
®
Drain tube
connected to the
cold water tank.
Storage
Drain the internal water tank before storing and ensure that you store your
brewer in a safe and frost free environment. It is suggested to store your
brewer in the upright position. If you store the brewer in a cold
environment, you run the risk of water freezing inside the brewer and
causing damage. When you prepare to use it after storage, we recommend
running three cleansing brews without a K-Cup
your brewer to a different location, turn the brewer off, unplug it and empty
the internal water tank. If your brewer has been in an environment below
freezing, please be sure to let it warm to room temperature for two hours
before using.
17
and set it aside. If the screw is tight,
26
fig.
you may need to use a flathead screw
driver. Pull the hot water tube
downward until the end is free (fig. 26).
Over a large pitcher, remove the plug
and drain the water from the internal
water tank into the pitcher.
CAUTION: If the brewer was not allowed
to cool sufficiently, the water draining
from the tube may be very hot. Recap
Drain tube
the tube. NOTE: To avoid losing parts,
connected to the
hot water tank.
when finished, re-insert the tube and
screw the panel back onto the brewer.
If you need assistance with your
brewer, please contact your Keurig
Authorized Distributor.
pod. If you plan to move
®