Section 3 Cleaning & Maintenance; De-Scaling Instructions; Storage - Keurig Elite B40 Manuel D'utilisation

Masquer les pouces Voir aussi pour Elite B40:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

SECTION 3 Cleaning & Maintenance

De-Scaling Instructions

A. PREPARE
Step 1: Make sure you have at least 48 ounces of undiluted white vinegar on
hand. You will also need an empty sink and a large mug (do not use a
paper cup).
Step 2: Empty the water in the Water Reservoir.
Step 3: Disable Auto Off feature.
B. FILL AND CLEAN
Step 1: Pour the vinegar into the Water Reservoir to fill.
Step 2: Place a large mug on the Drip Tray Plate and run a water brew cycle.
just press the Large Mug Button. Pour the
DO NOT USE A K-Cup,
contents of the large mug into the sink.
Step 3: Repeat the brew process 3 times.
Step 4: Now let the Brewer stand for at least 4 hours while still on.
C. RINSE
Step 1: Ensure the Water Reservoir is filled with fresh water.
Step 2: Place a large mug on the Drip Tray Plate and run a water brew cycle
without using a K-Cup
. Pour the contents of the large
®
mug into the sink.
Step 3: Repeat brew process until the Water Reservoir is empty.
Step 4: You may need to perform additional water brew cycles if you notice
any residual taste.
NOTE: If the red 'DE-SCALE' light is still illuminated on the LED Control Center
after completing the procedure, repeat the de-scaling procedure above.
Service
Beyond these recommended cleaning and maintenance procedures this
Brewer is not user serviceable, for service please refer to the Warranty
section of this guide.

Storage

Empty the Water Reservoir before storing and take care to ensure that you
store your Brewer in a safe and
store your Brewer in its
upright position
tank. If you store the Brewer in a cold environment, you run the risk of water
freezing inside the Brewer and causing damage. When you prepare to use it
after storage, we recommend rinsing the Water Reservoir with fresh water
and running three cleansing brews without a K-Cup.
If you plan to move your Brewer to a different location, turn the Brewer off,
unplug it and empty the Water Reservoir. If your Brewer has been in
an environment below freezing, please be sure to let it warm to room
temperature for at least 2 hours before using.
12 12
environment. Please be sure to
frost free
to avoid water leakage from the inner

Publicité

Chapitres

Table des Matières
loading

Table des Matières