Menu Controls And Indicators; Section 3 - Cleaning & Maintenance Cleaning; Descaling - Keurig K-Cup K130 Manuel D'utilisation

SECTION 2
Menu Controls & Indicators
Menu Controls
1. Power Button — is used to turn the brewer on/off.
2. BREW Button — is used to start a brew and is ready to be pressed once
the blue light starts flashing around the BREW Button.
Indicators
The PLACE CUP Indicator — flashes with a green light just before a brew
1.
cycle is about to begin. Place a 10 oz. mug on the Drip Tray when you see
this light.
The HEATING Indicator — flashes with a RED light when the water is
2.
being heated up for a brew. This will take two to three minutes.
SECTION 3
Cleaning & Maintenance
Cleaning External Parts
IMPORTANT: Make sure the brewer is unplugged before cleaning.
Regular cleaning of the brewer's external components is recommended.
Never immerse the brewer in water or other liquids. The housing
1.
and other external components may be cleaned with a damp, soapy, lint
free, non-abrasive cloth.
2. The Drip Tray can accumulate 8 oz. of liquid. The Drip Tray and Drip Tray
Plate should be periodically inspected and cleaned with a damp, soapy,
lint free, non-abrasive cloth. The Drip Tray and Drip Tray Plate should
not be put into the dishwasher. To remove the Drip Tray, simply slide it
toward you, keeping it level at all times to avoid spilling.
Cleaning the K-Cup Pack Holder Assembly
®
The K-Cup Pack Holder
5 1. Cleaning the Parts — ®
fig.
Assembly can be placed onto the top shelf of a
dishwasher. NOTE: Use low temperature cycles
in the dishwasher or wash with warm soapy
water. To remove the K-Cup ® Pack Holder
Assembly from the brewer open the cover by
pressing the PRESS TO OPEN Button. Grasp
the top of the K-Cup ® Pack Holder with one
hand while pushing up on the bottom of the
K-Cup Pack Holder from underneath with the
®
other until it releases (fig. 5). After cleaning,
8
align the K-Cup ® Pack Holder with the opening
6
fig.
using the two front ribs as a guide, and snap
into place from the top.
2. Cleaning the Funnel — The Funnel can be
removed from the K-Cup ® Pack Holder by
pulling on it until it snaps off (fig. 6). The Funnel
!
is dishwasher safe. To replace it, just snap it
back onto the K-Cup ® Pack Holder Assembly.
3. Cleaning the exit needle — The exit needle is
located on the inside bottom of the K-Cup
Pack Holder Assembly. Should a clog arise due
to coffee grinds, it can be cleaned using a
paper clip or similar tool. Remove K-Cup
Pack Holder assembly and detach Funnel.
Insert the paper clip (fig. 6) into the needle to
loosen the clog and push it out. The K-Cup
Pack Holder is dishwasher safe.
CAUTION: There are sharp needles that puncture the K-Cup ® pack above the
K-Cup Pack Holder and in the bottom of the K-Cup Pack Holder. To avoid
® ®
risk of injury, do not put your fingers in the K-Cup Pack Holder Assembly.
®
Descaling Your Brewer
Depending on the mineral content of your water, calcium deposits or scale
may build up in your brewer. Scale is non-toxic but if left unattended can
hinder brewer performance. Regularly descaling your brewer every 3-6
months helps maintain the heating element, and other internal parts that
come in contact with water. Calcium deposits may build up faster, making it
necessary to descale more often.
Before you begin, you will need a large ceramic mug, fresh water, descale
solution and access to a sink. Do not use a paper cup.
®
Properly follow the descaling procedure.
Descaling Procedure
®
STEP 1: FIRST DESCALING SOLUTION RINSE
• Turn on your brewer.
®
• Press the PRESS TO OPEN Button but do not add a K-Cup
Immediately lower Handle to open the Water Tank Lid.
• Pour one third (4.6 oz.) of Keurig Descaling Solution into the Water Tank
™
then add fresh water to the FILL LEVEL Indicator.
• Place a large ceramic mug on the Drip Tray Plate. Do not use a
paper cup.
• Lower the Handle and press the BREW Button.
• Discard the hot contents into sink.
STEP 2: SECOND DESCALING SOLUTION RINSE
• Repeat bullets 1 through 5 above.
9
pack.
®