Publicité
Les langues disponibles
Les langues disponibles
CTS22 - CTS40 - CTT40
It is very important that the transmission belt is installed with
the correct tension, in order to optimize its performance and
life.
To obtain the correct transmission belt tension, use the following
method:
■
Loosen the four adjusting plate fixing screws (1).
■
Loosen the nut (2) and operate on the screw (3) to adjust
the transmission belt (4) tension.
■
Measure the deflection of the indicated section, which
should be 5 ÷ 6 mm in the central part using a force of 50
N perpendicular to the same belt.
■
Lock the nut (2) and the four adjusting plate fixing screws
(1).
Tightness inspection
Hoses check
Make sure that connecting hoses (1) are in a good condition
and correctly fixed.
If the hoses are damaged, broken or badly connected to the
unions, they must be replaced.
When sticky materials are treated, check for possible clogging
along the hose, in the inlet and on the baffle plate inside the
filtering chamber.
To clean, scrape the inlet (2) from the outside to remove
deposits.
Filtering chamber gasket check for machines
equipped with dust container
If the gasket (1) between the container and the filtering chamber
(3) fails to guarantee sealing:
■
Loosen the four screws (2) that lock the filtering chamber
(3) against the machine structure.
■
Allow the filtering chamber (3) to lower down and tighten
the screws (2) once it has reached the sealing position.
If an optimal seal is not yet obtained or if there are tears, cracks,
etc., the gasket must be replaced.
Filtering chamber gasket check for machines
I
equipped with Longopac® system
GB
Ensure that the Longopac® bag is tight with the gasket (2).
Also check the seal of the gasket positioned on the discharge
clapet (1).
F
The gasket must be replaced if it is torn, cut, etc...
D
E
C313
Figure 20
Figure 21
Figure 22
Disposal
The crossed-out wheeled bin symbol on the
equipment indicates that used electrical and
electronic equipment must be collected and
disposed of separately from household waste. The
correct disposal of the equipment will help prevent
potential
negative
environment and human health.
Electrical and electronic household equipment must be
disposed of at the separate collection points in the residence
area. Please note that commercial electrical and electronic
equipment should be disposed of separately from the municipal
waste stream. We will be pleased to inform you about suitable
disposal options.
Wiring diagrams
In the case of machines equipped with an electrical control
panel, refer to the paper wiring diagram supplied with the
machine documentation.
18
consequences
for
Figure 23
[ NOTE ]
the
Publicité
