Haussmann PNT210-A Manuel De L'utilisateur page 22

MAINTENANCE
CLEAN AND INSPECT BEFORE EACH USE
CAUTION: Disconnect tool from air supply before cleaning and inspection.
Correct all problems before putting the tool back in service.

solutions to wipe exterior of tool only if necessary. De not soak tool with cleaning
solutions. Such solutions can damage internal parts.
 Inspect trigger and safety mechanism to assure system is complete and
functional: no loose or missing parts, no binding or sticking parts.
 Keep all screws tight. Loose screws can cause personal injury or damage the tool.
 If the tool is used without an in-line oiler, place 2 drops of air tool oil into the
air inlet of the tool at the beginning of each workday and after about 1 hour
of continuous use. Frequent but not excessive lubrication is required for best
performance. Oil added through the airline connection will lubricate all internal
parts. Use only air tool oil. Do not use oil with detergents or other additives.
These can cause damage through accelerated wear to the seals in the tool.
 Use a small amount of oil on all exterior moving parts and pivots.
 Dirt and water in the air supply are major causes of pneumatic tool wear . See
the section on SETUP: AIR SOURCE above for more information.

solutions sparingly and only if necessary. Do not soak parts in the solutions.
CAUTION: Such solutions may damage O-rings and other parts.
TROUBLESHOOTING
WARNING: Stop using the tool immediately if any of the following problems
occur. Serious personal injury may result. Any repairs or replacements must be
CAUTION:
 Disconnect the tool from air supply before performing any service procedure.
 When inserting new or re-installing O-rings, make sure they are clean and
lubricated with an O-ring lubricant.
22
PNT210-A
flammable
.
!
!
!
!