Publicité
Les langues disponibles
Les langues disponibles
A
B
G
C
IMPORTANT SAFETY INSTRUCTIONS
Use only a pressure-regulated compressed air source to limit the air pressure
supplied to the tool. The regulated pressure must not exceed 110 PSI. If the
regulator fails, the pressure delivered to the tool must not exceed 180 PSI. The
tool could explode which will cause death or serious personal injury.
Always disconnect air resource:
a) before making adjustments.
b) when servicing the tool.
c) when clearing a jam.
d) when tool is not in use.
e) when moving to a different work area, as accidental actuation may occur,
causing injury.
Never connect tool to an air source that may exceed 180 PSI. Over pressurizing
the tool may result in bursting, abnormal operation, breakage of the tool or
serious injury to persons. Use only clean, dry, regulated compressed air at the
rated pressure or within the rated pressure range as marked on the tool. Always
verify prior to using the tool that the air source has been adjusted to the rated air
pressure or within the rated air-pressure range.
SPECIFICATIONS
The HAUSSMANN nailer shoots most standard 18 gauge brad nails. It can be
used for cabinet making and furniture assembly, door and window casing
manufacturing, aluminum and vinyl siding installation, soffit work, trim and
moulding application, picture framing and applications where gluing is necessary,
but clamping is impractical.
Shoots industry standard 18 gauge brad nails from 3/8"(10 mm) to 1-1/4"(32 mm)
length.
Operating pressure: 70-110 PSI
Air consumption: 4-5 CFM @ 90 PSI
Air inlet: 1/4" NPT
Rubber grip
FUNCTIONAL DESCRIPTION
Figure 1 names the major components of the
HAUSSMANN brad nailer:
F
A. Deflector
B. Body
C. Quick release
D. Magazine
E. Fixed latch
E
F. Air plug
G. Trigger
D
Fig.1
19
Publicité
