Nutricia flocare Infinity Mode D'emploi page 92

EN
• Press the "DOSE=VOL" key and make sure the value is put at 0 ml indicated by the word "CONT". This means the pump will
run in a continuous mode.
• Start the pump by pressing "START/STOP".
• The arcs around the word "run" start rotating.
• The flow rate (ml/h) is displayed whilst functioning.
Ensure that the volume of nutrition in the container is greater than is actually needed, i.e. more than the set DOSE to be
administered, so as to avoid excessive air bubbles getting in the feeding line.
ON/OFF ml/h
d
the hold mode, with the last flow rate (ml/h) displayed in the LCD:
• Set the flow rate by pressing the "+" or "-" key.
If another parameter is displayed:
• Press first the "ml/h" key followed by "+" or "-" key to adjust the flow rate. The flow rate can be set between 1 and 400 ml/h,
with increments of 1ml.
• Press the "DOSE=VOL" key and install the volume to be administered with the "+" and "-" key. The range goes from 1 - 4000 ml,
with steps from 1ml.
• Start the pump by pressing "START/STOP".
During functioning the following parameters can be found in the display:
• By pressing the "ml/h" key the "flow rate" is displayed.
INFO
When the required volume or dose has been delivered, "END OF DOSE" will appear and the pump will beep (or mute, depending
upon the pumps' configuration (see paragraph: set up mode).
• Press the "START/STOP" key to pause the pump.
• Change the program by pressing the required key (ml/h or DOSE=VOL) and adjust using the "+" or "-" keys.
• Restart the pump by pressing the "START/STOP" key again.
403260087_r1.indd 90 403260087_r1.indd 90
TO SET A DOSE
+
400 ml/h
DOSE=VOL
d d
-
1 ml/h
• By pressing the "INFO" key the total volume since the memory was cleared will be visualized.
TO CHANGE THE FEEDING PROGRAM DURING FUNCTIONING
+
4000 ml
START/STOP
d d
-
1 ml
-90-
18/04/23 10:27 18/04/23 10:27