Technical Data; Symbols; Functional Description; Intended Use - Festool MFK 700 EQ Guide D'utilisation

Technical data

Power consumption
Rotational speed (no load)
Tool holder
optional:
Max. routing tool diameter
Weight
Safety

Symbols

V Volts
A Amperes
Hz Hertz
~ Alternating current
n No load speed
0
Class II Construction
rpm Revolutions or reciprocation per minute
Ø Diameter
Warning of general danger
Read the Operating Instructions/Notes!
Advice or tip


Functional description

The pictures for the scope of delivery are on a
fold-out page at the beginning of the instruction
manual. When reading of the manual you can fold
out this page for having always an overview of the
machine.
[1-1] MFK 700 with large surface router table
[1-2] Side stop with guide rods and fi ne adjuster
(accessory)
[1-3] Extraction hood for large surface router
table with extractor connector
[1-4] Router table for edge veneer with feeler roller
and extraction hood (only in SET scope of de-
livery)
720 W
10000 - 26000 rpm
8 mm (0.31")
6 mm (0.24")
1/4"(6.35 mm)
26 mm (1")
1.9 kg (4.2 lbs)
/II
8

Intended use

The MFK 700 EQ is designed for routing wood,
plastic and similar materials.
The user shall be responsible and
liable for damages and accidents resulting from
misuse or abuse of this tool.

Electrical connection

The network voltage must conform to the voltage
indicated on the rating plate. A 16 A safety fuse (for
120 V) or a corresponding protective circuit-breaker
is required.
See the following fi gure [2] for connection and dis-
connection of the power cable.
Always switch the machine off
before connecting or disconnecting the power
cable!
2
Extension cable
If an extension cable is required, it must have a suf-
fi cient cross-section so as to prevent an excessive
drop in voltage or overheating. An excessive drop in
voltage reduces the output and can lead to failure
of the motor. The table below shows you the correct
cable diameter as a function of the cable length for
the MFK 700. Use only U.L. and CSA listed extension
cables. Never use two extension cables together.
Instead, use one long one.
Total Extension Cord
Lenght (feed)
Cord size (AWG)
Note:
 The lower the AWG number, the stronger the
cable.
25 50 100 150
18 16 16 14