Publicité
Les langues disponibles
Les langues disponibles
(16) Camera remote socket
(17) Flash socket
(18) Battery compartment
(19) Mounting foot
(20) Suspension eye
(21) 1/4" tripod thread
(22) Knurled ring
(23) Channel selector
(24) On/Off switch
4. Inserting the batteries (fig. B)
Switch off transmitter or receiver before inserting the
batteries. Open the battery compartment cover (7 or
18) and insert two AAA batteries. Pay attention to po-
larity. Close the battery compartment.
5. Selecting the channel (fig. C)
Transmitter and
receiver must
be set on the same
channel for accurate communication. Press the chan-
nel selector (10 or 23) repeatedly and the channel indi-
cators (4 or 15) will light up in the order shown in fig. C.
Seven channels can be selected. Channel indicators
go out automatically after four seconds.
14
6. Camera remote control operation
Wireless remote control (fig. D)
Mount the MultiTrig AS 5.1R receiver to the hot shoe
of your camera and lock it by rotating the knurled ring
(22). Choose the appropriate release cord (25) and
connect the camera remote socket (16) of the recei-
ver with the remote socket on your camera. If the hot
shoe of your camera is already occupied by another
device, you may use an accessory bracket to mount
the receiver. Switch on the receiver and then switch
on your camera.
Switch on the MultiTrig AS 5.1T transmitter and press
the release button (2) halfway. The status indicators
(1 and 12) of transmitter and receiver light up green
and the camera's autofocus and exposure metering
are activated.
Press the release button (2) fully. The status indicators
(1 and 12) of transmitter and receiver light up red, the
camera shutter is released.
Available operating modes are single shot, multi shot
and long exposure (bulb). Remember to set your ca-
mera to the corresponding mode.
For a single shot press the release button (2) once to
shoot.
Publicité
