Installation - Stiebel Eltron HDB-E 12 Si Utilisation Et Installation

INSTALLATION

Installation
10. Installation
This chapter describes installation in accordance with the factory
settings.
For further installation options, see chapter "Installation / Instal-
lation alternatives".
f Open the appliance. f
f Push in both locking hooks. Pull the lower back panel for- f
ward to remove.
f Mark out the holes for drilling using the installation template. f
f Drill the holes and secure the mounting bracket with f
2 screws and 2 rawl plugs (screws and rawl plugs are not
part of the standard delivery).
Note
If you are installing the appliance with flexible water
connections, also secure the back panel with a screw.
www.stiebel-eltron.com
f Fit the mounting bracket. f
≥ 30
f Prepare the power cable. f
Making the water connection
Material losses
!
Carry out all water connection and installation work in
accordance with regulations.
f Seal and insert the twin connectors. f
1 2
1 Tee
2 Cross-piece
f Secure the tee and cross-piece, with a flat gasket each, to the f
twin nipples.
Fitting the strainer
Material losses
!
The strainer must be fitted for the appliance to function.
f When replacing an appliance, check whether the f
strainer is installed.
f Fit the strainer provided in the cold water inlet of the f
appliance.
160
HDB-E Si | 21