Publicité
Les langues disponibles
Les langues disponibles
A10-14—Status Indicator Light
• Pulsing: Emptying/Mop washing
• Red: Dock error
• Light off: Powered Off/Charging/
Drying
A10-15—Water Filter
A10-16—Dock Base
A10-17—Hot Air Outlet
Power Cable Storage
A11
A11-1—Cable Outlets
A11-2—Power Port
A11-3—Cable Slot
Note:
Power cable can exit at either side.
Installation
B
Important Information
B1
B1-1—Tidy cables and loose items from
the ground and move any unstable,
fragile, precious, or dangerous
items to prevent personal injury
or property damage due to items
becoming tangled in, struck by, or
knocked over by the robot.
B1-2—When using the robot in a raised
area, always use a secure physical
barrier to prevent accidental falls
that may result in personal injury or
property damage.
Note:
When using the robot for the first time, follow
it throughout its whole cleaning route and watch for
potential problems. The robot will be able to clean by
itself in future uses.
Position the charging dock
B2
B2-1—Place the dock on a hard and flat floor.
Attach the base by pressing down
both sides of the base firmly, and then
pressing the connecting part in the
middle until you hear a click.
Note:
Remove the water tanks and the dustbin before
moving the dock.
B2-2—Connect the power cable to the back
of the dock, and keep the excess
cable inside the storage slot.
Place the Dock
B3
Place the dock on a hard and flat floor
(wood/tile/concrete etc.), flat against a wall.
Keep at least 1 m (3.3 ft) of clearance in
front and above. Make sure the location has
good WiFi for a better experience with the
mobile app, and then plug it in.
B3-1—More than 1m (3.3 ft)
B3-2—Do not block the air inlet
Notes:
• If the power cable hangs vertically to the ground, it
may be caught by the robot, causing the dock to be
moved or disconnected.
• The dock indicator is on when the dock is powered on,
and off when the robot is charging.
• The dock indicator turns red if an error occurs.
• Place the dock on a flat floor away from fire, heat, and
water. Avoid narrow spaces or locations where the
robot may be suspended in the air.
07
• Placing the dock on a soft surface (carpet/mat) may
cause the dock to tilt over and cause problems
docking and departing.
• Keep the dock away from direct sunlight or anything
that may block the dock location beacon; otherwise,
the robot may fail to return to the dock.
• Do not use the dock without clean water tank, dirty
water tank, high-speed maintenance brush, dustbin,
dust bag, or water filter.
• Maintain the dock according to the maintenance
instructions. Do not clean the dock with a wet cloth or
tissue.
• All docks are subject to water-based tests before
leaving the factory. It is normal that a small amount of
water remains in the waterway of the dock.
Power on and charge the robot
B4
Press and hold the
button to power
on the robot. Wait until the power light is
steady, and then place the robot on the
dock to charge. The robot is equipped
with a built-in high-performance lithium-
ion rechargeable battery pack. To maintain
battery performance, keep the robot charged
during normal use.
B4-1—Power Indicator
Dock Status Indicator Light turns off, Robot Power
Indicator pulsing:
Charging
Note:
The robot may not be turned on when the battery
is low. In this case, connect the robot to the dock.
Publicité
