Publicité
Les langues disponibles
Les langues disponibles
Common Issues
Problem
The LED status indicator light on the
dock is steady red.
Reduced emptying performance or
unusual noise when emptying.
Robot voice alert: Error 42.
Maintenance brush jammed. Clean it
and remove blockages.
Reduced mop washing performance.
Auto Drying is not working.
Auto-emptying is not working.
The mop is not washed.
Solution
• The dustbin or dust bag is not in place. Check and correct installation.
• Voltage error. Check that local voltage meets the requirements listed on the dock.
• Check clean water tank placement or refill as required.
• Check dirty water tank placement or empty as required.
• Check that the water filter has been correctly installed.
• The main brush or main brush cover is not properly installed. Check and correct installation.
• The filter, air duct, suction inlet, air inlet, or dustbin is blocked. Clean to remove blockages.
• If the brush stops at the left side, it may be jammed. Remove any items jamming it.
• If the brush stops at the right side, the filter may be blocked or is not installed in place. Clean
and correct installation.
• The mop is not attached properly. Reinstall.
• The floor is dirty. Change the mop washing mode to "Deep" in the app for better cleaning.
• Auto Drying is disabled. Check in-app settings.
• Auto drying starts only after mopping or mop washing.
• Auto-emptying is disabled. Check in-app settings.
• Dock dustbin is not installed. Check and install.
• Auto-emptying will not be triggered if the robot returns to the dock without cleaning.
• The robot will not auto-empty after returning to the dock in Do Not Disturb (DND) mode.
Adjust cleaning or DND duration, or start emptying manually.
• The mop will not be washed if not used.
• The robot will not return to the dock for mop washing if it does not start from the dock or no
dock is found on the app map.
• Check tank placement and refill or empty as required.
• Check that the water filter has been correctly installed.
15
Publicité
