Publicité
Les langues disponibles
Les langues disponibles
Washable Filter
D6
* Clean weekly and replace the filter every 6-12 months.
D6-1—Open the filter cover and remove the
filter.
D6-2—Rinse the filter repeatedly and tap it
to remove as much dirt as possible.
Note:
Do not touch the surface of the filter with your
hands, brush, or hard objects to avoid potential damage.
D6-3—Allow 24 hours for the filter to dry
thoroughly and reinstall it.
VibraRise Mop
D7
* Clean after each use and replace every 3-6 months.
D7-1—Remove the VibraRise mop cloth from
the VibraRise mop mount. Clean the
VibraRise mop cloth and air-dry it.
Note:
A dirty VibraRise mop will affect the cleaning
performance. Clean it before use.
D7-2—Slide the mop cloth in from the
opening of the attachment slot then
stick it flat in place.
Robot Sensors
D8
* Clean monthly.
Use a soft, dry cloth to wipe and clean all
sensors, including:
D8-1—Dock Locator
D8-2—Reactive Tech Obstacle Avoidance
Sensor
D8-3—Wall Sensor
D8-4—Mop Wash Sensor
D8-5—Carpet Sensor
D8-6—Cliff Sensors
Moving Dock
D9
Remove the water tanks and the dustbin
before moving the dock. Grip the handle on
the back with one hand and the inner side
of the front, as shown. Do not grip the base
because it is not designed for lifting.
Dirty Water Tank
D10
* Clean as required.
Clean the dirty water tank as needed. Open
the dirty water tank lid and pour out the
dirty water. Fill the tank with clean water,
close the lid, lock it, and shake. Pour out the
dirty water. Close the lid and then re-install.
Charging Contact Areas
D11
* Clean monthly.
Use a soft dry cloth to wipe the charging
contacts on the robot and the dock.
High-Speed Maintenance
D12
Brush
* Clean as required and replace every 6-12 months.
1. Lift the high-speed maintenance brush
latch and remove the brush.
2. Remove any entangled objects in the high-
speed maintenance brush and rinse it clean.
Reinstall the brush and latch it in place.
11
Water Filter
D13
* Clean as required.
Unlock the water filter and remove it from
dock. Unlock the filter latch, rinse the filter
clean. Use a soft, dry cloth to wipe the cleaning
tank, and then reinstall the filter. Press down
the filter until you hear it lock with a click.
Base
D14
* Clean as required.
D14-1—Clean the base and air inlet with a
soft, dry cloth.
D14-2—If the outlet is blocked, clean it with
a cotton swab. If any debris falls into
the dryer base, remove the base and
shake the debris out.
Replacing the Disposable
D15
Dust Bag
* Replace the disposable dust bag when it is full.
D15-1—Lift the dustbin and remove the bag
vertically as shown.
Note:
Pulling the dust bag handle to remove the bag
will seal the bag to prevent leakage.
D15-2—Discard the dust bag and clean
around the filter with a dry cloth.
D15-3—Slot in a new disposable dust bag
as shown. Slide until it reaches the
bottom of the slot and reinstall the
dustbin securely.
Note:
Always install a dust bag before putting back the
dustbin top lid to avoid auto-emptying without the bag.
You can also disable auto-emptying in the app.
Publicité
