Publicité
Les langues disponibles
Les langues disponibles
UNPACKING AND CONTENT
IMPOrTANT:
faulty or that a part is missing. If you find anything wrong, do not operate the tool until
the parts have been replaced or the fault has been rectified. Failure to do so could result
in serious personal injury.
CONTENTS IN PACKAGE
Description
Impact Wrench
Impact Sockets
Storage Case
ASSEMBLY AND ADJUSTMENTS
WArNING:
disconnected before adjusting, adding accessories, or checking a function on the
tool.
INSTALLING OR REMOVING THE BATTERY PACK (FIG 2)
WArNING:
removal of the battery pack.
• To install the battery pack, slide the battery pack (6) into the
bottom of the tool housing all the way until it locks in place
with a click, as shown in fIG 2. Lightly pull on the battery to
ensure it is locked into place and will not accidentally fall out
of the tool, causing an injury.
• To remove the battery pack, pull the battery pack away from
the tool while depressing the battery locking tab (5).
OPErATION
CHARGING THE BATTERY (FIG 3)
NOTE:
Always Check that the power supply corresponds to
the voltage on the ratings plate.
• Plug the charger (7) into a 120 Volt AC power source. The green
light (7b) on the charger will illuminate, indicating the charger
is powered.
• Slide the battery (6) all the way into the charger until it locks
in place with a click, as shown in fIG 3. The red light (7a) will
illuminate, indicating that the battery is charging.
• The red light will go off after charging is complete.
• Batteries may become warm while charging. This is normal.
• If battery is hot after continuous use in the tool, allow it to cool
down to room temperature before charging. This will extend
the life of your batteries.
NOTE:
It takes approximately 90 minutes to charge up a completely discharged battery.
STARTING AND STOPPING THE IMPACT WRENCH
To Turn the Tool On,
switch. Depressing the switch further will produce more speed.
To Turn the Tool Off,
8
Due to modern mass production techniques, it is unlikely the tool is
Q'TY
Description
1
Charger (GLACH2015A)
4
Battery Pack (GLAB20HP)
1
Operator's Manual
Always be sure that the tool is switched off and the battery is
Always be sure that the tool is switched off before insertion or
squeeze the trigger switch (4-fIG1). The wrench is equipped with a variable-speed trigger
release the trigger switch.
20V
MAX Lithium-ion Impact Wrench Kit
Operator's Manual
Q'TY
1
1
1
5
7
7a
7b
GLIW20AK
6
FIG 2
6
FIG 3
Publicité
