Velleman VTSSC75 Mode D'emploi page 4

warranty.

Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and
the dealer will not accept responsibility for any ensuing defects or problems.

Do not switch the device on immediately after it has been exposed to changes in temperature.
Protect the device against damage by leaving it switched off until it has reached room temperature.
4. Features

electronic temperature control

password lock

sensor and heater fail notification

LED display with digital temperature scale (°C or °F)

with on/off switch

ceramic heating element with temperature sensor

spare bits:
0.4 mm: BITC03
o
0.8 mm: BITC201
o
1.6 mm: BITC20
o

spare parts:
barrel and nut assembly + heater holder: VTSSC75/SP1
o
ceramic heater: VTSSC75/SP2.
o
5. Overview
Refer to the illustrations on page 2 of this manual.
VTSSC75
1 display
2 SET button
3 DOWN button (▼)
4 UP button (▲)
5 power switch
6 earth connection
display
A temperature indication
fuse replacement
X screw
6. Description

This soldering station is designed to meet the present and future needs of the electronic production
industry. The VTSSC75 is engineered to meet the stringent demands of hobbyist, maintenance
personnel, and production staff alike.

The electronic circuitry enables you to set soldering temperatures between 150 and 480 °C (302 to
896 °F) without replacing the tip. The temperature is maintained to within ± 5 °C (± 9 °F) of the
normal operating temperature.

Heater fail detection: If the heater circuit fails, the display shows "H--E" and heater power is cut.

Temperature lock features: The temperature can be locked with a password for use in a production
line.

The "zero voltage" switching design protects voltage and current sensitive components (such as
CMOS devices) against transient voltage spikes that can be caused by switching the power or heater
on/off, or other environmental conditions.

The highly insulated ceramic heating element and 60 W power result in rapid heat-up, instant
recovery, and superior heat transmission.

The ergonomic and slender handle with a comfortable rubber grip prevents operator fatigue. The
soldering iron is attached to the base unit using a non-burning silicone rubber cord.

The tip is grounded through the power unit to ensure leakage of less than 0.4 mV.
V. 04 – 17/08/2015
VTSSC75
7 barrel
8 nut
9 bit
10 heater element
11 heater holder
12 handle
B temperature unit (°C or °F)
C heating indication
F fuse
4 ©Velleman nv