Changing The Water In The Boiler; Cup-Warmer (Where Contemplated) - La Cimbali M39 GT R2 Utilisation Et Installation

12. Changing the water in the boiler

"Before operating the machine change the
water in the boiler."
Ensure that the indication on the display corresponds to the
working pressure value.
Keep a hot water distributor key (12) pressed down for
approximately 5 seconds.
The following message will be displayed: "WATER CHANGE".
The water from the boiler will drain from the hot water nozzle
(8) (60 - 70% ca. of the total capacity).
The boiler resistance and all dispensing keys will be disabled.
Dispensing will stop automatically (Note. The delivery can
be interrupted at any time by means of the push button
STOP 35).
After the procedure, the machine will return to its normal
13. Cup Warmer (if provided)
CAUTION: do not cover the cup warmer tray
with any type of cloth.
The machines have a cup tray (23) for stocking the cups.
Only place cups and glasses used with the coffee machine on
the cup tray. No other objects must be placed on the tray.
Thoroughly drain the cups before placing them on the tray.
To activate the resistance of the cup warmer tray (23) press
button (22); to change the cup-warmer power, press the
(22) key a number of times.
- All LEDS on = full power
- All LEDS off = OFF
To desactivated the heating of tray (23) press more times
the key (22) until all the leds are off.
N.B. The heating of the cup warmer tray (23) is deactivated
during the automatic switch off phase.
The condition in effect at the time when the machine was
switched off will be restored the next time the machine
automatically switches on.
To access settings for cup-warmer power levels, hold the
cup-warmer button (22) down for longer than 5 seconds.
12 35
8
23
22
SCALDATAZZE
050%
Select the heating level pressing the
Additional changes are possible using the
(31) keys.
2) exit the menu and leave the settings unchanged by
pressing the key (24).
13 EN
12 12
30
24
31
< 075% < 100%
button (29).
(30) and
29
OK
key