AfG Berlin EM70/40 PCG Serie Installation-Emploi-Entretien page 28

- Remove and replace the component.
- Reassemble all parts. For assembly, proceed in
reverse order.
REPLACING THE MAIN BURNER, PILOT BURNER,
THERMOCOUPLE AND IGNITER.
- Remove the hotplate.
- Remove the control panel and internal guards.
- Remove and replace the component.
- Reassemble all parts. For assembly, proceed in
reverse order.
GAS OVEN
REPLACING THE GAS VALVE AND PIEZO IGNITER.
- Remove the control panel.
- Remove the bulb from its seat on the side of the
oven.
- Remove and replace the component.
- Reassemble all parts. For assembly, proceed in
reverse order.
REPLACING THE BURNER
- Open the oven door.
- Remove the panel on the oven door.
- Remove the floor and the plate positioned on top of
the burner.
- Remove and replace the component.
- Reassemble all parts. For assembly, proceed in
reverse order.
REPLACING THE PILOT BURNER AND IGNITER.
- Open the oven door.
- Remove the panel on the oven door.
- Remove the floor and the plate positioned on top of
the burner.
- Remove and replace the component.
- Reassemble all parts. For assembly, proceed in
reverse order.
REPLACING THE THERMOCOUPLE
- Remove the control panel.
- Open the oven door.
- Remove the panel on the oven door.
- Remove the floor and the plate positioned on top of
the burner.
- Remove and replace the component.
- Reassemble all parts. For assembly, proceed in
reverse order.
ELECTRIC HOB
REPLACING THE KNOB AND INDICATOR LIGHT
- Remove the control panel.
- Remove and replace the component.
- Reassemble all parts. For assembly, proceed in
reverse order.
REPLACING THE HOTPLATE.
- Remove the control panel and internal guards.
- Remove and replace the component. Screw spacer
M8 taken from the old part onto the new one.
- Reassemble all parts. For assembly, proceed in
reverse order.
ELECTRIC OVEN
REPLACING THE KNOB AND INDICATOR LIGHT
- Remove the control panel.
- Remove and replace the component.
- Reassemble all parts. For assembly, proceed in
reverse order.
REPLACING THE WORKING THERMOSTAT AND
SAFETY THERMOSTAT
- Remove the control panel.
- Remove the bulb from its seat on the side of the
oven.
- Remove and replace the component.
- Reassemble all parts. For assembly, proceed in
reverse order.
REPLACING THE HEATING ELEMENT
- Remove the oven floor (only for lower heating
elements).
- Undo the screw securing the element to the oven
and pull the element out by approx. 10 cm.
- Reassemble all parts. For assembly, proceed in
reverse order.
22. CLEANING THE INTERIOR
Check the condition of the inside of the appliance.
Remove any built-up dirt.
Check and clean the fumes exhaust system.
23. MAIN COMPONENTS
GAS HOB
- Gas tap
- Main burner
- pilot burner
28