AfG Berlin EM70/40 PCG Serie Installation-Emploi-Entretien page 23

Installation and appliance maintenance must be
carried out by qualified technicians authorized by
the manufacturer, in compliance with current safety
standards and the instructions in this manual.
Appliance maintenance and conversion to a
different type of gas must be carried out by
qualified technicians
manufacturer, in compliance with current safety
standards and the instructions in this manual.
11. USING THE GAS HOB
The appliance is designed for cooking foods
contained in pots and pans.
The pilot burners have to be turned on manually.
Check that the flame spreaders are correctly placed
on the burners.
The additional hotplates
manufacturer can only be used on 6 Kw burners.
Pans used on the hotplates must be smaller in
diameter than the hotplate itself. They must not
protrude from the hotplate.
On the burner of 6kW must be use the pans with
minimum diameter of 150mm and maximum
diameter of 400 mm.
On the burner of 10kW must be use the pans with
minimum diameter of 250mm and maximum
diameter of 500 mm.
BURNER IGNITION AND EXTINCTION
The gas tap control knob has the following
positions:
OFF
PILOT IGNITION
MAX. FLAME
MIN. FLAME
PILOT IGNITION
Press and turn knob to "pilot on".
Press the knob down fully and light the pilot with a
flame.
Hold the knob down for about 20 seconds before
releasing it. If the pilot flame goes out, repeat the
operation.
authorized by the
provided by the
MAIN BURNER IGNITION
To light the main burner, turn the knob from "pilot
on" to "max. flame".
For the minimum flame, turn the knob from "max.
flame" to "min. flame".
TURNING OFF
Turn the knob from "max. flame" or "min. flame"
to "pilot on".
To shut off the pilot, press the knob lightly and turn
it to "off".
12. USING THE HOTPLATE/SIMPLE SERVICE
The appliance is designed for cooking foods
contained in pots and pans.
The highest temperatures are in the centre of the
hotplate.
Check that the flame spreader is correctly placed on
the burner. Raise the central disc on the hotplate.
BURNER IGNITION AND EXTINCTION
The gas tap control knob has the following
positions:
OFF
PILOT IGNITION
MAX. FLAME
MIN. FLAME
PILOT IGNITION
Press and turn knob to "pilot on".
Press the knob down fully and light the pilot using
the piezoelectric igniter.
Hold the knob down for about 20 seconds before
releasing it. If the pilot flame goes out, repeat the
operation.
The pilot flame can be seen through the peep hole
on the control panel.
The pilot light can be lit by bringing an open flame
up to the nozzle. Raise the central disc on the
hotplate.
The gas tap control knob has the following
positions:
23