Publicité
12
Dell PowerConnect RPS-600 Setup Guide
All manuals and user guides at all-guides.com
To operate the RPS-600 after installation:
Plug one end of the switch DC power cord into the connector labeled
1
"RPS" on the back of the switch. Connect the other end of the switch
DC power cord to any available RPS connector on the back of the
RPS-600.
Attach the AC power cord to the RPS-600 and to an AC power outlet.
2
The switch is now using both power supplies simultaneously. You can
monitor the status of the two power supplies through the front panel LEDs
on your PowerConnect switch and the RPS-600.
Technical Information
Power Supply Specification
The PowerConnect RPS-600 contains four independent 150-W power
supplies.
•
The dimension of each supply is 4.0 x 7.0 x 1.334 inches
(1.16 x 17.78 x 3.338 cm) (max.).
•
Each power supply has a single output of 12 V. The following table
details the characteristics of each power supply.
Publicité
