ECOVACS ROBOTICS DEEBOT OZMO610 Manuel De L'utilisateur page 15

4
Charge DEEBOT
Place DEEBOT on the Docking Station
making sure the Charging Contacts on
DEEBOT and the Docking Station Pins make
a connection.
Charge DEEBOT for at least 4 hours before
the first use.
* Make sure to turn the robot's Power Switch to the ON position before charging.
* AUTO Mode Button blinks when DEEBOT is charging. AUTO Mode Button stops glowing when
DEEBOT is fully charged.
* When DEEBOT completes the cleaning cycle or when battery power gets low, DEEBOT
automatically returns to the Docking Station to recharge itself. DEEBOT can also be sent back to the
Docking Station at any time by pressing the Return to Charger Button on the Remote Control.
* Empty any remaining water from the Reservoir and remove the Cleaning Cloth Plate before charging
DEEBOT.
5
Start
Press the AUTO Mode Button on DEEBOT or
on the Remote Control. DEEBOT starts to
work immediately in AUTO Cleaning Mode.
6 Pause
Pause DEEBOT by pressing the AUTO Mode
Button on DEEBOT or
* DEEBOT can be directed to move forward,
backward, left and right using the Direction
Control Buttons on the Remote Control when
it is Paused.
* The AUTO Mode Button on the robot's Control
Panel stops glowing after the robot is paused
for more than 10 minutes. Press AUTO Mode
Button on the robot or press any button on the
Remote Control to wake up the robot.
3. Operating and Programming
on the Remote Control.
13
FR-CA EN