Publicité
Les langues disponibles
Les langues disponibles
en Basic operation
Basic operation
Basic operation
You can find out everything you need
Basic operation
to know about operating your appli-
ance here.
Switching on the appliance
Press
.
1.
a The appliance begins to cool.
"Set the required temperature."
2.
→ Page 42
Operating tips
¡ Once you have switched on the
appliance, the set temperature is
only reached after several hours.
Do not put any food in the appli-
ance until the temperature has
been reached.
¡ The housing to the left, the right
and beneath the cool-fresh com-
partment may heat up slightly tem-
porarily. This prevents condensa-
tion in the area of the door seal.
¡ When you close the door, a va-
cuum may be created. The door is
then difficult to open again. Wait a
moment until the vacuum is offset.
Switching off the appliance
Press
.
▶
a The appliance stops cooling.
Setting the temperature
After you have switched on the appli-
ance, you can set the temperature.
Setting the refrigerator
compartment temperature
Press / repeatedly until the tem-
▶
perature display shows the re-
quired temperature.
42
The recommended temperature in
the refrigerator compartment is
4 °C.
Setting the cool-fresh compartment
temperature
Note: The temperature in the cool-
fresh compartment is kept at around
0 °C.
"If frost forms on the food items in
▶
the cool-fresh compartment, set a
higher cool-fresh temperature."
→ Page 48
Additional functions
Additional functions
Find out which additional functions
Additional functions
which can be used for your appli-
ance.
Super cooling
Super cooling cools the refrigerator
compartment to make it as cold as
possible. This cools food and drinks
quickly through.
Switch on Super cooling before pla-
cing large quantities of food in the
freezer compartment.
Note: When Super cooling is
switched on, increased noise may
occur.
Switching on Super cooling
Press
.
▶
lights up.
a
Note: After approx. 15 hours, the ap-
pliance switches to normal operation.
Switching off Super cooling
Press
.
▶
a The previously set temperature is
displayed.
Publicité
