Publicité
Les langues disponibles
Les langues disponibles
Problem and alarm code
The level of water inside the
appliance is too high.
The display shows iF1.
The appliance stops and
starts more times during op‐
eration.
The programme lasts too
long.
The displayed programme
duration is different than the
duration in the consumption
values table.
The remaining time in the
display increases and skips
nearly to the end of pro‐
gramme time.
Small leak from the appli‐
ance door.
The appliance door is diffi‐
cult to close.
The appliance door opens
during the wash cycle.
Rattling/knocking sounds
from inside the appliance.
The appliance trips the cir‐
cuit-beaker.
Refer to "Before first use",
"Daily use", or "Hints and
tips" for other possible
causes.
Once you have checked the appliance,
deactivate and activate the appliance. If
Possible cause and solution
•
Switch the appliance off and on.
•
Make sure that the filters are clean.
•
Make sure that the outlet hose is installed at the right
height above the floor. Refer to the installation instruc‐
tions.
•
It is normal. It provides optimal cleaning results and en‐
ergy savings.
•
If the delayed start is set, cancel the delay setting or
wait for the end of the countdown.
•
The pressure and the temperature of the water, the var‐
iations of the mains supply, the options, the quantity of
dishes and the degree of soil can change the pro‐
gramme duration.
•
This is not a defect. The appliance is working correctly.
•
The appliance is not levelled. Loosen or tighten the ad‐
justable feet (if applicable).
•
The appliance door is not centred on the tub. Adjust the
rear foot (if applicable).
•
The appliance is not levelled. Loosen or tighten the ad‐
justable feet (if applicable).
•
Parts of the tableware are protruding from the baskets.
•
The AirDry function is activated. You can deactivate the
function. Refer to "Settings".
•
The tableware is not properly arranged in the baskets.
Refer to basket loading leaflet.
•
Make sure that the spray arms can rotate freely.
•
The amperage is insufficient to supply simultaneously all
the appliances in use. Check the socket amperage and
the capacity of the meter or turn off one of the applian‐
ces in use.
•
Internal electrical fault of the appliance. Contact an Au‐
thorised Service Centre.
the problem occurs again, contact an
Authorised Service Centre.
For alarm codes not described in the
table, contact an Authorised Service
Centre.
ENGLISH
23
Publicité
