Makita XTR01 Mode D'emploi page 10

Installing or removing the offset
base
Optional accessory
1.
Press the shaft lock, then loosen the collet nut.
1
2
► 1 . Collet nut 2. Shaft lock 3. Wrench
2. Remove the collet nut and the collet cone.
► 1 . Collet nut 2. Collet cone
3.
Install the pulley on the tool by pressing the shaft
lock and tightening the pulley with the wrench.
1
► 1 . Wrench 2. Pulley 3. Shaft lock
4. Loosen the screws on the base plate, and then
remove the base plate.
3
► 1 . Base plate
5. Open the lock lever of the offset base, then insert
the tool into the offset base.
1
2
► 1 . Lock lever
6. Mount the belt to the pulley by rotating the belt
manually.
2
3
► 1 . Pulley 2. Belt
7. Close the lock lever.
10 ENGLISH
1
1
1
2