Publicité
Les langues disponibles
Les langues disponibles
► 1 . Lock lever
8.
Attach the base plate by tightening the screws.
► 1 . Base plate
9.
Insert the collet cone and the trimmer bit into the
offset base, and then tighten the collet nut.
1
2
3
► 1 . Trimmer bit 2. Collet nut 3. Collet cone
10. Insert the hex wrench into the hole of the offset
base, and then tighten the collet nut with the wrench.
1
► 1 . Collet nut 2. Wrench 3. Hex wrench
To remove the base, follow the installation procedure in reverse.
NOTE: You can also mount the belt to the pulley with-
out removing the base plate as shown in the figure.
1
► 1 . Pulley 2. Belt
Installing or removing the plunge base
Optional accessory
1.
Open the lock lever of the plunge base, then insert
the tool into the plunge base all the way aligning the
groove on the tool with the protrusion on the plunge base.
► 1 . Lock lever
11 ENGLISH
1
2
3
1
2
1
Publicité
