Makita XTR01 Mode D'emploi page 16

Using the tool with the offset base
The offset base is convenient for work in a tight area
such as a corner.
Using the trimmer base with the
offset base plate and grip
The offset base plate can also be used with a trimmer
base and a grip attachment (optional accessory) for
more stability.
1.
Loosen the screws on the base plate, then remove
the base plate from the offset base.
► 1 . Offset base plate 2. Trimmer base plate
2. Attach the offset base plate to the trimmer base by
tightening the screws.
3.
Attach the grip attachment and the bar type grip to
the offset base plate by tightening the screws.
1 2
1
2
► 1 . Bar type grip 2. Grip attachment
The knob type grip removed from the plunge base can
be installed on the offset base instead of the bar type
grip.
1
2
► 1 . Screw 2. Knob type grip
Using the tool with the plunge base
Always hold the grips firmly with both hands during
operation. Operate the tool in the same way as the
trimmer base.
Using the straight guide
Optional accessory
1. Install the straight guide to the guide holder by
tightening the wing nut. Insert the guide holder into the
holes in the plunge base, and then tighten the wing
bolts.
16 ENGLISH