Publicité
Les langues disponibles
Les langues disponibles
P8 20162461_V01 T5274_K150_UCG_FINAL.p8R1.pdf 4C(CMYK) ZB2319 2016-11-25 Size:8.5X5.5in
P8 20162461 T5274_K150_UCG_FINAL.pdf 4C(CMYK) ZB2319 2016-11-02 Size:8.5X5.5in
SECTION 1 Setup & First Brew
11.
Your brewer may display "HEATING PLEASE WAIT" as it heats water for
the next brew cycle.
Stopping the Brew Process
If you need to stop the brewing after the process has started, press and
release the Power Switch to turn the brewer 'OFF.' The flow of coffee, tea,
hot cocoa, or other beverage will stop and the heating element and the LCD
Screen will shut off.
NOTE: You may get less coffee, tea, hot cocoa, or other beverage in your cup
during your next brew. We recommend that you perform a cleansing brew with
water only after a terminated brew. Then your next
9
brew will be the volume you have selected.
fig.
adding Water
Fill Water Reservoir
The LCD Screen will indicate when the water
level in the Water Reservoir is low or if the Water
Reservoir has been removed by displaying the
words "FILL WATER RESERVOIR" (fig. 9).
The brewer will not allow you to brew when
"FILL WATER RESERVOIR" is displayed (fig. 9).
The Water Reservoir can be filled in three ways.
1.
Remove the Water Reservoir from the brewer
by first removing the Water Reservoir Lid from
the Water Reservoir, then lifting the Water
Reservoir straight up and away from the
brewer. Fill with water to and not beyond the
MAX FILL line. Place the Water Reservoir
back on the brewer and replace the Water
Reservoir Lid.
IMPORTANT: Do not remove the Water
Reservoir during the brewing process.
2.
Lift the Water Reservoir Lid and pour water
directly into the Water Reservoir while it is still
attached to the brewer, then replace the Water
Reservoir Lid.
The brewer can also be connected directly
3.
into the water line. To order a K150
Direct Plumb Kit (#40559) please call
1.888.CUP.BREW (287.2739) or contact
your Keurig Authorized Distributor.
8
Publicité
