SilverCrest SLE 200 B2 Mode D'emploi page 16

Handling and use
This section provides you with important information on handling and using the
appliance.
Switching the appliance on/off
♦ Press the
You will hear a beep and the
the
♦ Press the
You will hear a beep and the
the
NOTE
► The appliance always starts up with the last-selected setting.
► If the appliance shuts down due to a power failure, it will automatically
restart with the last–selected setting when power is restored.
♦ If a timer has been programmed, the appliance switches off permanently
after the specified time has elapsed (1–24 hours).
♦ If the relative humidity value has been set in the
program, the appliance switches off as soon as the value is reached. If the
value is exceeded, the appliance switches back on again.
♦ When the water tank 4 is full or removed, dehumidification stops. The
fan continues to run for approx. 3 minutes and then switches off. If the
water tank 4 has been removed or is not correctly inserted, the
WATER TANK FULL o lights up. If switched on, the appliance will also
beep for approx. 20 seconds.
NOTE
► The water tank 4 must be completely inserted into the appliance, other-
wise the condensation water cannot be properly collected.
SLE 200 B2
STANDBY button s to switch on the appliance.
DRY LAUNDRY LED t lights up permanently.
STANDBY button s to switch off the appliance.
DRY LAUNDRY LED t goes out.
DEHUMIDIFICATION LED r or
DEHUMIDIFICATION LED r or
DEHUMIDIFICATION
GB │ IE │ 13 ■