Télécharger Imprimer la page

SilverCrest SLE 200 B2 Mode D'emploi page 11

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 52
Do not permanently install the appliance. Position the appli-
ance so that its side panels have a clearance of at least 20
cm from walls or other objects and ensure a clearance of at
least 30 cm from the front, rear and top panels of the appli-
ance in order to ensure good air circulation. Take care not to
obstruct the air inlet and outlet opening.
The appliance may only be operated in rooms with an ambi-
ent temperature of 5°C to 32°C.
Use the appliance only in rooms up to 16 m².
The appliance must be installed, operated and stored in a
room with a floor area greater than 4 m
If the appliance is operated in unventilated areas, these
must be designed in such a way that the refrigerant cannot
accumulate anywhere in the event of refrigerant leakage.
Otherwise, a combustible mixture may be formed.
The appliance may only be stored in rooms without perma-
nent sources of ignition (e.g. open flames, a switched-on gas
appliance or an electric heater).
The appliance must be stored in a way that does not dam-
age it.
Clean the air filter before it becomes heavily soiled.
While draining via a hose, ensure that it does not become
blocked and that the open end of the hose is positioned at a
lower level than the outlet aperture. The end of the hose must
be positioned above a drain.
Operate the appliance only together with the water tank or
with the hose installed.
Connect the safety plug only to a properly installed, easily
accessible plug socket with protected contacts, the voltage
of which corresponds to the specifications on the rating
plate. The plug socket must remain easily accessible even
after connection.
8 
GB │ IE
2
.
SLE 200 B2

Publicité

loading