Publicité
Les langues disponibles
Les langues disponibles
Always position the cord away from the rotating bit and DO nOT
•
wrap the cord around your arm or wrist
chuck you may lose control of the drill and become entrapped by the cord, causing personal injury.
When using the drill, DO nOT position yourself between the tool and
•
a wall or post
torque of the tool could crush your hand, arm or leg against a stationary object.
If the bit jams or binds in the work,
•
prevent personal injury. unplug the drill from the power source and then remove the drill bit from
the work. Do not attempt to free the jammed drill bit by repeatedly starting and stopping the drill
motor; this action could result in injury.
Do not use dull or damaged bits and accessories.
•
more likely to bind in the work piece.
Do not use bits larger then those recommended
•
causing loss of tool control and personal injury. Large bits may also overload the drill, causing
motor and gear damage.
When removing the drill bit from the tool avoid contact with skin
•
Allow sufficient time for the bit to cool down or use proper protective gloves to handle the bit or
accessory. Drill bits and accessories may be hot after prolonged use.
Wear cushioned gloves and take frequent rest breaks.
•
generate considerable vibration when in operation which may be harmful to your hands and arms.
Use only percussion-type carbide tipped bits for hammer drilling
•
do not attempt cutting reinforcing rod with percussion-type bits.
Check the tool and remove any chuck keys or adjusting wrenches
•
before switching the tool "On".
you or a bystander, causing an injury.
WARnIng:
OR OTHER AIRBORnE PARTICLES, InCLUDIng WOOD DUST, CRYSTALLInE
SILICA DUST AnD ASBESTOS. Direct particles away from face and body.
Always operate tool in a well-ventilated area and provide for proper dust
removal. Use dust collection system wherever possible. Exposure to the dust
may cause serious and permanent respiratory or other injury, including silicosis
(a serious lung disease), cancer, and death. Avoid breathing the dust, and
avoid prolonged contact with the dust. Allowing dust to get into your mouth or
eyes, or lay on your skin may promote absorption of harmful material. Always
use properly fitting nIOSH/OSHA approved respiratory protection appropriate
for dust exposure, and wash exposed areas with soap and water.
. If the bit jams or becomes bound in the work piece, the sudden reaction
USE OF THIS TOOL CAn gEnERATE AnD DISBURSE DUST
SAVE THESE INSTRUCTIONS
. If the cord is caught by the rotating bit or
immediately release the switch trigger to
Keys and wrenches can fly off at high speed striking
Dull or damaged bits are
. They are more likely to jam,
Hammer drills can
.
and
7
Publicité
