DeWalt DXCMTE6590811 Guide D'utilisation page 27

CODE POSSIBLE CAUSE
26 Detergent type oil being used in pump
27 Extremely light duty cycles
28 Piston rings damaged or worn
29 Cylinder or piston damaged or worn
30 Compressor cylinder finish worn
31 Water in pump oil
Manual lock unloader lever in open position
32
Regulator open
33
Engine fuel tank empty
34
POSSIBLE SOLUTION
Drain oil and refill pump with full synthetic non-detergent air
compressor oil.
Run unit for longer duty cycles. It is recommended to run at high
throttle 50-75% of the run time and idle for 25% of the run time.
Contact a D WALT factory service center or a D
e
service center.
Contact a D WALT factory service center or a D
e
service center.
Contact a D WALT factory service center or a D
e
service center.
Drain oil and refill pump with full synthetic non-detergent air
compressor oil.
Rotate manual lock unloader lever to the closed perpendicular
position.
Rotate the regulator knob counterclockwise to its built-in stop and push
knob in to lock in place.
Add gasoline, see engine's instruction manual for correct procedure.
27
WALT authorized
e
WALT authorized
e
WALT authorized
e