Publicité
Les langues disponibles
Les langues disponibles
HUMID AREAS
In frequently humid areas, moisture may form in the pump and
produce sludge in the oil, causing running parts to wear out
prematurely. Excessive moisture is especially likely to occur if
the unit is located in an unheated area that is subject to large
temperature changes. Two signs of excessive humidity are external
condensation on the pump when it cools down and a "milky"
appearance in
compressor oil. You may be able to prevent
moisture from forming in the pump by increasing ventilation or
operating for longer intervals.
NOISE CONSIDERATIONS
Consult local officials for information regarding acceptable noise
levels in your area. To reduce excessive noise, use vibration mounts
or silencers, relocate the unit or baffle walls. Contact a D
service center or call 1-888-895-4549 for assistance.
TRANSPORTING
WARNING: Risk injury from lifting. Unit weighs more than 185
lbs. (83,9 kg) Do not move or lift without assistance.
NOTICE: Risk of property damage. The wheels and handle do
not provide adequate clearance, stability or support for pulling
the unit up and down stairs or steps. The unit must be lifted, or
pushed up a ramp.
NOTICE: Risk of property damage. Place engine fuel valve lever
(O) in the OFF position before moving or transporting unit.
When transporting the
compressor in a vehicle, trailer,
etc. ensure that the air tank is
drained and the unit is secured
and placed on a protective mat
on a flat horizontal surface.
DO NOT store in a standing
WALT
e
Q, R
Q, R
S
position.
NOTE: Use recommended tie down points (Q) when transporting.
Use care when driving so to avoid tipping the unit over in the
vehicle. Damage can occur to the unit or surrounding items if unit is
tipped. Use a ramp if loading or unloading the unit from a height of
more than 12" (30.5 cm).
LIFTING
Always lift from the recommended lift points (R).
WARNING: Risk injury from lifting. Unit weighs more than 185
lbs. (83,9 kg) Do not move or lift without assistance.
NOTICE: Risk of property damage. Place engine fuel valve lever
(O) in the OFF position before moving or transporting unit.
MOVING
1. Grasp handles (S) of compressor, and lift compressor high
enough so unit can be rolled on the front tire.
WARNING: Risk of unsafe operation. Ensure proper footing and
use caution when rolling compressor so that unit does not tip or
cause loss of balance.
NOTICE: Risk of property damage. Place engine fuel valve lever
(O) in the OFF position before moving or transporting unit.
2. When location is reached slowly lower rear of compressor to
ground. Always store compressor in a horizontal position. DO
NOT store in a standing position.
NOTE: Should the unit tip over, hard starting and smoking will occur
due to oil spillage.
PREPARATION FOR USE
Pre-Start Checklist (Fig. 1)
1. Ensure engine ON/OFF switch (C) is in the OFF position.
2. Ensure air tank is drained, see Draining Air Tank under
Maintenance.
13
Publicité
