Kohler K-702205 Guide D'installation page 10

5. Install the Door Panels
CAUTION: Risk of injury. The door panels are very heavy. Two people should lift them into place.
NOTE: Perform these installation steps from outside the bath/shower.
IMPORTANT! Risk of product damage and personal injury. It is critical the bumpers prevent direct
contact between the door panel and the metal frame. If the door panel makes direct contact it will result in
breakage of the glass and bodily harm.
NOTICE: Risk of product damage. For the protection of your bath unit, use a drop cloth or similar
material as a protective cover during these steps.
IMPORTANT! Make sure that the "non coated" label is facing the outside of the bath/shower. The coated
side of the glass panels should face the inside the shower for ease of cleaning.
Install the Inside Panel
Run a rag along the each of the inside rails of the top track to remove debris.
Lift the inside door panel with the rollers facing away from you.
Position the rollers on the inside rail of the top track.
Move the inside panel to the same side the showerhead is located.
Install the Outside Panel
Lift the outside door panel with the rollers facing you and position the rollers on the outside rail.
Position the rollers on the outside rail of the top track.
Move the outside panel to the side opposite the showerhead.
1054857-2-B
Inside Panel
10
Outside Panel
Kohler Co.