Kärcher IVR 100/30 Ef Manuel D'instructions page 15

Only lift the device via the provided crane
grommet.
Ensure that there will be no unintentional
unhooking of the lifted load.
The crane may exclusively be operated by
qualified staff.
No people may be located within the haz-
ard zone of the crane.
Do not leave the device hanging unattend-
ed on the crane.
Illustration F
1. Switch off the device and disconnect
from the power supply.
2. Open the suction head lock.
3. Attach a suitable hoist to the crane
grommet.
4. Use the crane to lift the suction head and
place it on a suitable surface.
Ending operation
1. Switch off the device using the on/off
switch
2. Empty and clean the collection contain-
er.
3. Remove the accessories and clean and
dry them as necessary.
Transport
CAUTION
Failure to observe the weight
Risk of injury and damage
Be aware of the weight of the device during
transport and storage.
1. When transporting in vehicles, secure
the device against slipping and tipping
over according to the applicable guide-
lines.
Storage
CAUTION
Failure to observe the weight
Risk of injury and damage
Be aware of the weight of the device during
transport and storage.
1. Store the device indoors only.
Care and servicing
1. Rinse off the device and accessories at
regular intervals using a suitable liquid
and allow to dry.
2. Check the bag filter regularly for dam-
age. Replace the bag filter if damaged.
Replacing the filter
See graphics page for illustrations
Illustration G
CAUTION
Failure to observe the weight
Risk of injury and damage
Use a suitable lifting device to lift the suc-
tion head.
1. Remove the suction head (see chapter
Removing the suction head).
2. Loosen the screws of the tensioning
rings.
3. Remove the small deflector plate.
4. Remove and replace the filter.
5. Insert the new filter.
Ensure that the filter is inserted correctly
during installation.
6. Fit the tensioning rings and screw them
on.
Replacing the bag filter
See graphics page for illustrations
Illustration H
Screws
1
Tensioning ring
2
Bag filter
3
Cleaning device
4
CAUTION
Failure to observe the weight
Risk of injury and damage
Use a suitable lifting device to lift the suc-
tion head.
1. Remove the suction head. 
(see chapter Removing the suction
head)
2. Remove the filter inlay by the handles
and turn it around.
Illustration I
3. Remove the screws and disassemble
the cleaning device.
4. Loosen the tensioning ring screws.
5. Remove the bag filter.
6. Dispose of the foam filter.
7. Insert the new bag filter.
8. Insert the new foam filter.
English 15