Publicité
Les langues disponibles
Les langues disponibles
CONNECTING AN ELECTRIC DRYER
TOOLS YOU WILL NEED
Slip-joint pliers
Flat-blade
screwdriver
MATERIALS YOU WILL NEED
Safety glasses
Gloves
3/4" Strain relief
(UL recognized)
49-3000311 Rev 2
Installation Instructions
Phillips
screwdriver
Level
Dryer power cord kit
(not provided with dryer)
UL rated 120/240V, 30A with
3 or 4 prongs. Identify the
plug type as per the house
receptacle before purchasing
line cord.
Stacking installations may
require a power cord up to 6
feet in length.
Before making the electrical connection, turn off the
circuit breaker(s) or remove the dryer's circuit fuse(s) at
the electrical box. Be sure the dryer cord is unplugged
from the wall. NEVER LEAVE THE ACCESS COVER
OFF THE TERMINAL BLOCK.
WARNING
- Electrical Shock Hazard
Disconnect power supply before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
WARNING
- Shock Hazard
Certain internal parts are intentionally not grounded
and may present a risk of electric shock only during
servicing.
Service personnel – DO NOT contact the following
parts while the appliance is energized: motor start
capacitor, motor metal holder, and drum wheel shaft.
RECEPTACLE FOR CONNECTION
TO SPECIFIED WASHERS
Receptacle
Not a general-use
receptacle – For use
with washers
GFW148, QFW150,
GFQ14, or GNW128
only.
NOTE: An auxiliary
cover may be present
on some models.
Remove the auxiliary
cover if connecting
washer models
GFQ14 or GNW128.
15
Publicité
