Publicité
Les langues disponibles
Les langues disponibles
Fault
The cleaning robot does
not start
The cleaning robot can-
not connect to
the WLAN/The cleaning
robot goes offline
Disposal
WARNING
This device contains Lithium-Ion rechargea-
ble batteries. The removal and proper dis-
posal of lithium-ion batteries must be
carried out in accordance with national and
state regulations.
Warranty
The warranty conditions issued by our sales company
responsible apply in all countries. We shall remedy pos-
sible malfunctions on your device within the warranty
period free of cost, provided that a material or manufac-
turing defect is the cause. In a warranty case, please
contact your dealer (with the purchase receipt) or the
next authorised customer service site.
(See overleaf for the address)
24
Cause
Ambient temperature is below 0 °C or
above 35 °C.
Charging state is too low.
Laser distance sensor (LiDAR) is
blocked.
Collision sensor is dirty or too close to the
virtual wall.
Fall sensors are dirty.
The water reservoir or dust container is
not installed or incorrectly installed.
Filter not installed or incorrectly installed. 1. Make sure that the filter is correctly in-
Filters dirty.
Wiper cloth or wiper cloth holder not or in-
correctly installed.
The cleaning robot is jammed or stuck.
The cleaning robot or one of its wheels
has no floor contact.
The cleaning robot is not connected to
the network or is not within the range of
the WLAN signal.
The WLAN signal is too weak.
Rectification
1. Use the cleaning robot at temperatures
above 0 °C and below 35 °C.
1. Charge the cleaning robot.
1. Clean the laser distance sensor with a dry
cloth.
2. Remove obstacles blocking the laser dis-
tance sensor.
3. Move the cleaning robot to another location
and start it.
1. Remove foreign objects by carefully tap-
ping on the collision sensor.
2. Move the cleaning robot to another location
and start it.
1. Clean the fall sensors with a dry cloth.
1. Ensure the water reservoir or the dust con-
tainer is installed and correctly latched into
place, see chapter Installing the water res-
ervoir or. Installing the dust container
stalled.
1. Clean the filter, see chapter Cleaning the
filter.
2. If the error persists, replace the filter, see
chapter Replacing the filter.
1. Ensure that the wiper cloth and wiper cloth
holder are correctly installed, see chapter
Installing the wiper cloth or Installing the
wiper cloth holder.
1. Remove obstacles.
1. Place the cleaning robot on a flat surface.
1. Make sure that the cleaning robot is con-
nected to the network and is within the
range of the WLAN signal.
2. Make sure that the WLAN password is cor-
rect.
3. Reset the WLAN and connect again (5
GHz WLAN networks are not supported).
1. Make sure that the cleaning robot is within
range of the WLAN signal.
Technical data
Electrical connection
Nominal power
Nominal voltage of battery
Battery pack type
Nominal voltage of charger
Rated current charger
Battery capacity
Rechargeable battery nominal ca-
pacity
Operating time when battery is ful-
ly charged in normal operation
English
W
36
V
14,4
Li-ION
V
100-240
A
0,8
mAh
4800
mAh
5200
min
120
Publicité
