Inventum IKI3020 Mode D'emploi page 22

3
before first use
Before you use the appliance for the first time, please do as follows: Carefully unpack the appliance and remove all the
packaging material. Keep the material (plastic bags and cardboard) out of reach of children. Check the appliance after
unpacking for any damage, possible from transportation. Clean the glass with a damp cloth. Check that the voltage in your
home corresponds with the voltage printed on the bottom of the appliance and plug it in a socket. Follow the installation
instructions in chapter 7 for installing the hob.
4
operation of the appliance
Use only suitable cookware on the induction hob .
After the mains voltage is applied all displays can light up for a moment. After that, the hob is in stand-by mode and is ready
for use.
The hob is controlled with electronic sensors which are operated by touching the related keys. Each sensor activation is
followed by a sound signal.
SWITCHING THE APPLIANCE ON
Switch the hob on by touching the ON/OFF key for a few seconds. The displays of the cooking zones all show [0.] and the
dots blink. If there is no cooking zone selected within 20 seconds, the hob will automatically shut off.
SWITCHING THE APPLIANCE OFF
Switch the hob off at any time by touching the ON/OFF key for a few seconds.
The ON/OFF key always has priority in the switch off function.
SWITCHING ON A COOKING ZONE
Press on the + key of the cooking zone you wish to use. There is a static dot indication on the selected cooking zone display
and the dots on the other displays turn off.
Place the pan on the cooking zone. Select the heat setting by using the increase heat setting key + or the decrease heat
setting key -.
To get food quickly to the boil, select the desired heat setting and touch the P key to activate the Boost function.
BOOST FUNCTION
The Boost function gives extra power and can be activated for each cooking zone. A cooking zone must be selected, the
heat setting set on the desired setting and the
appears in the display of the selected cooking zone.
When using the Boost function the maximum available power will be divided between two cooking zones which work as a
pair.
It is possible that the maximum available power for these two cooking zones together is exceeded. In that case the power
of the second cooking zone will be decreased automatically. The necessary power reduction is shown by blinking of the
corresponding cooking zone display. The display will blink for 3 seconds and during that time further adaptations of the
settings are allowed before the power is automatically reduced.
SWITCHING A COOKING ZONE OFF
Select the cooking zone you want to switch off by pressing the corresponding key. Touch the - key to decrease the heat
setting to [0]. By pressing the keys + and - simultaneously, the setting turns directly to [0].
If the cooking zone is hot, the displays shows an [H] instead of [0].
SWITCHING OFF ALL COOKING ZONES AT ONCE
To switch off all cooking zones at once, press the ON/OFF key. The displays which are still hot an [H] appears.
RESIDUAL HEAT DISPLAY
The residual heat display shows the glass is still too hot to touch around the cooking zone.
After switching off the cooking zone, the corresponding display shows [H]. As soon as the temperature has decreased
enough the [H] indication will disappear.
22
• English
key (Boost) must be pressed. The Boost function is activated when a P