Franke FMY 98 P Manuel De L'utilisateur page 5

ACCESSORIES
WIRE SHELF
The number of accessories may vary depending on which model is purchased.
Other accessories can be purchased separately from the After-sales Service.
INSERTING THE WIRE SHELF AND OTHER
ACCESSORIES
Insert the wire shelf horizontally by sliding it across
the shelf guides, making sure that the side with the
raised edge is facing upwards�
Other accessories, such as the drip tray and the
baking tray, are inserted horizontally in the same way
as the wire shelf�
FITTING THE SLIDING RUNNERS
Remove the shelf guides from the oven and remove
the protective plastic from the sliding runners�
To secure the guide, press
the lower portion of the
clip firmly against the shelf
guide� Make sure that the
runners can move freely�
Repeat these steps on the
other shelf guide on the same level�
Please note: The sliding runners can be fitted on any level.
DRIP TRAY
Fasten the upper clip of the
runner to the shelf guide
and slide it along as far as it
will go� Lower the other clip
into position�
BAKING TRAY
REMOVING AND REFITTING THE SHELF GUIDES
• To remove the shelf guides, lift them up and pull the
lower parts out of their lodgings: The shelf guides can
now be removed�
• To refit the shelf guides, first fit them back into their
upper seating� Keeping them held up, slide them into
the cooking compartment, then lower them into
position in the lower seating�
EN
SLIDING RUNNERS
1
2
5